TM9-2350-222-20-1-3
FUEL-WATER SEPARATOR FLUID PRESSURE FILTER REPLACEMENT (Sheet 4 of 7)
-
Using 7/16 inch wrench, turn bleed cap (K)
counterclockwise until loose. Let fuel-water
filter drain.
Using socket, remove three capscrews,
(2D engine). Remove clamp (M) from filter
(c).
NOTE
It may be necessary to tap sensor
j u s t above threaded portion of
adapter with 1/8 inch punch and
hammer.
15. Using socket, loosen capscrew (N) to provide
movement to fuel-water separator filter (C).
NOTE
Go to step 20 if you have a 2A
engine.
16. Using 9/16 inch wrench, remove upper sensor
(P) from fuel-water separator filter (C).
17. Tag upper sensor (P) to make sure of correct
installation.
18. Using 9/16 inch wrench, remove lower sensor
(Q) from fuel-water separator filter (C).
19. Tag lower sensor (Q) to make sure of correct
installation.
Go on to Sheet 5
TA149062
7-280