T M 9-2350-222-20-1-3
FUEL RETURN HOSE (RIGHT FUEL TANK) REPLACEMENT (Sheet 2 of 2)
NOTE
Put rags (Item 65, Appendix D) `under each connection before
removing hose end fittings.
REMOVAL:
Using socket, loosen and remove bolt and
1.
lockwasher (A) from hose clamp (B). Throw
lockwasher away.
2.
Using 1-7/16 inch wrench on hose and fitting
(C), and 1-1/2 inch wrench on fitting (D), hold
hose at point (C) while loosening fitting (D)
away from hose and fitting (C).
3.
Using 1-7/16 inch wrench, loosen fitting (with
hose) (E). Remove hose.
INSTALLATION:
1.
Lightly coat threads of both male hose ends with sealing compound (Item 24, Appendix D).
3.
Using 1-7/16 inch wrench, secure fitting (with hose) (A).
Using socket, secure clamp (B) with bolt and new lockwasher (C).
3.
4.
Using 1-7/16 inch wrench on hose and fitting and 1-1/2 inch wrench on fitting (E), hold hose at
point (D) while securing fitting (E).
5.
Ground hop engine and allow it to run for brief
time while checking for leaks. If leak is
detected, stop engine and tighten fitting. If
fittings do not leak, disconnect ground hop.
6.
7.
Fill fuel tanks.
End of Task
TA148991
7-243