TM 9-2350-222-20-1-3
FUEL TANK (RIGHT) FILLER REPAIR (Sheet 5 of 6)
INSTALLATION:
1.
Install strainer (A) in fuel tank (B).
2.
Install filler neck (C) on fuel tank (B).
3.
Using allen wrench, secure filler neck (C) to
fuel tank (B) using eight screws (D).
4.
If required, use slip joint pliers and install
lockwire (Item 59, Appendix D) (E) in eight
screws (D).
5.
Using two new gaskets (F) and new washers (G),
assemble seal assembly (H) and install eight
new screws (J) finger tight.
6.
Install seal assembly (H) on filler neck. While
holding filler neck in position, use screwdriver,
and tighten screws (J) until gaskets (F) and (G)
are compressed to form tight seal between fill
neck and hull.
Go on to Sheet 6
TA141423
7-163