TM 9-2350-222-20-1-3
DUST DETECTOR FILTER STRIP AND COVER REPLACEMENT (Sheet 3 of 3)
INSTALLATION:
Install filter strip (A) into retaining strap
1.
(B) and insert into cover (C).
2.
Install new preformed packings (D), (E),
and (F) into cover (C).
Pull out filter strip (A) so it extends about
3.
1/2 inch past edge of cover (C).
Position assembled cover (C) onto turbo-
4.
5.
Install screw and washer (H) through chain
fastener (J) and cover (C).
6.
Install screw (K) and packing with
retainer (L).
7.
Install screw and washer (M).
8.
Using wrench, tighten screws (H), (K), and (M).
Perform dust detector operational test (page 10-350.19).
9.
End of Task
* U.S. GOVERNMENT PRINTING OFFICE: 1991-543- 025 40067
7-148.14
Change 2