TM9-2350-222-20-1-3
PERSONNEL HEATER FUEL PUMP REPLACEMENT (Sheet 3 of 3)
INSTALLATION:
1.
Using 1/2 inch wrench, install elbow (A) into
pump (B).
2.
Using 7/16 inch wrench, install elbow (C) into
pump (B).
NOTE
When
installing
heater pump,
make
sure
cable
bracket is secured w i t h pump
mounting bracket.
NOTE
Be sure elbows (A) and (C) are
alined with the chalk marks on
the pump.
3.
Mount condenser bracket and fuel pump (B) to plate. Using fingers, install two screws (D) and flat
washers (E).
4.
other side of mounting plate.
Using socket, tighten screws (D) while holding
5.
nuts (G) with 7/16 inch wrench,
6. Using 5/8 inch wrench, connect and tighten nut
(H) to connect hose (J) to 45elbow.
7.
Using 9/16 inch wrench, connect and tighten
nut (K) of tube (L) to 90' elbow.
8.
Plug electrical connector (M) to harness (N).
9.
Operate personnel heater (TM 9-2350-222-10).
End of Task
TA141473
7-69