TM9-2350-222-20-1-3
TUBE ASSEMBLY (FUEL INJECTION PUMP INLET TO BULKHEAD ELBOW) REPLACEMENT
(Sheet 4 of 5)
2.
Using fingers, install bulkhead elbow (C) in hole
in front side of engine bulkhead.
3.
Using 3/4 inch wrench to hold bulkhead elbow
(C) and 1 inch wrench, install flat washer (D),
new lockwasher (E), and nut (F) on bulkhead
elbow (C).
4.
Using 3/4 inch wrench, turn bulkhead elbow (C)
until alined with hose assembly (G). Tighten
nut (F).
5.
Using 1 inch wrench to hold nut (F) and 7/8
inch wrench, install tube assembly (A) on
bulkhead elbow (C).
6.
Using 7/8 inch wrench, install hose assembly
(G) on bulkhead elbow (C).
Go on to Sheet 5
TA141506
7-35