TM9-2350-222-20-1-3
TUBE ASSEMBLY (FUEL INJECTION PUMP INLET TO BULKHEAD ELBOW) REPLACEMENT
(Sheet 3 of 5)
Using 7/8 inch wrench, remove tube assembly
7.
(C) from fuel injection pump adapter (G).
8.
Using fingers, remove tube assembly (C) from
vehicle.
CLEANING AND INSPECTION:
1.
Using clean rags and dry cleaning solvent (Item
65 and 54, Appendix D), clean elbow and tube
assembly mounting hardware thoroughly.
Using wire brush, clean threaded parts.
2.
Inspect elbow and tube assembly mounting
hardware for bends, breaks, rounded edges,
wear, or thread damage. Replace if required.
Inspect adapter on fuel injection pump for
3.
thread damage.
INSTALLATION:
NOTE
C o a t pipe threads of fittings
w i t h sealing compound (Item
before
Appendix D)
27,
installation.
1.
Using 7/8 inch wrench, install tube assembly
(A) on fuel injection pump adapter (B).
Go on to Sheet 4
TA141505
7-34