TM9-2350-222-20-1-3
ENGINE OIL COOLER INLET OR OUTLET HOSE REPLACEMENT (Sheet 3 of 3)
INSTALLATION:
Using 1-1/2 inch wrench, install hose (A)
1.
or (B) to connector (C).
Using 1-1/2 inch wrench, install hose (A) or
2.
(B) while holding fitting (D) with 9/16 in.
wrench.
3.
Using screwdriver and 3/8 inch wrench,
install clamp (E) on hose (A) if removed
during disassembly.
4.
Position new sealing washer (F) over vent
hole (on 2D engine only).
Using 9/16 inch wrench, install vent bolt (G)
5.
through new washer (F) (on 2D engine only).
6.
Using socket and torque wrench, tighten
drain valve (H) to a minimum of 150 lb-in
(17 Nm). DO not overtighten. (On 2D
engine only)
`7.
engine at idle until oil temperature is in
normal operating range (TM 9-2350-222-10).
8.
Check oil level. Add oil as required
(LO9-2350-222-12).
9.
10.
End of Task
TA253184
Change 1 6-1 88.3/( 6-1 88.4 blank)