TM9-2350-222-20-1-3
ENGINE OIL COOLER INLET OR OUTLET HOSE REPLACEMENT (Sheet 2 of 3)
REMOVAL:
1.
Using 9/16 inch wrench, remove vent bolt
(A) and sealing washer (B) (on 2D engine
only).
2.
Throw washer (B) away (on 2D engine
only).
3.
Using 3/4 inch wrench, loosen oil drain
valve (C) six complete turns (on 2D engine
only).
4.
Using screwdriver and 3/8 inch wrench,
remove clamp (D) on hose (E) if clamp is
attached to hose. If clamp (D) is not
attached to hose (E), go to step 5.
5.
Position drip pan under engine oil cooler
connector (G).
6.
Using 1-1/2 inch wrench, remove fitting
(F) from connector (G).
Using 1-1/2 inch wrench on hose (E) or (J)
7.
and 9/16 in. wrench on fitting (H), remove
hose (E) or (J).
Go on to Sheet 3
TA253183
6-188.2 Change 1