TM9-2350-222-20-1-3
ENGINE TO TRANSMISSION OIL LINE TUBE ASSEMBLIES (INNER AND OUTER)
REPLACEMENT (2D ENGINE) (Sheet 3 of 4)
INSTALLATION:
Position new gaskets (A) and (B) onto adapters (C) and (D).
1.
-
2.
Using 1-5/8 inch socket, install adapter (C) into oil cooler (E) and adapter (D) into trans-
mission mount (F).
3.
Using 1-5/8 inch socket, adapter, and torque wrench, tighten adapters (C) and (D) to 50 lb-
.
ft (67.7 Nm).
CAUTION
Do not allow adapters to turn when tightening oil cooler
line tube nuts. Do not overtighten tube nuts. Damage to
the transmission oil coolers could result.
4.
Position tube (G) through engine shroud and, using 1-5/8 inch wrench to keep adapters (C)
and (D) from turning, use a 1-1/2 inch wrench to tighten tube nuts (H) and (J) onto the
adapters.
5.
Position new gaskets (K) and (L) onto adpaters (M) and (N).
6.
Using 1-5/8 inch socket, install adapter (M) into oil cooler (E) and adapter (N) into trans-
mission mount (F).
7.
Using 1-5/8 inch socket, adapter, and torque wrench, tighten adapters (M) and (N) to 50 lb
ft (67.7 Nm).
8.
Position tube (P) through engine shroud and, using 1-5/8 inch wrench to keep adapters (M)
and (N) from turning, use 1-1/2 inch wrench to tighten tube nuts (Q) and (R) onto the
adapters.
Go on to Sheet 4
6-187
Change 4