TM9-2350-222-20-1-3
ENGINE TO TRANSMISSION OIL LINE TUBE ASSEMBLIES (INNER AND OUTER)
REPLACEMENT (2D ENGINE) (Sheet 2 of 4)
NOTE
Upon removing tubes and fittings, seal powerplant openings
w i t h plastic barrier material (Item 41, Appendix D) and
masking tape (Item 57, Appendix D) to prevent unnecessary
Remove plastic
barrier material and masking tape when installing tubes and
fittings.
REMOVAL:
1.
Put rags under oil line disconnect points to catch oil when lines are disconnected.
1.1. Using 1-5/8 inch wrench to hold adapter (A), use 1-1/2 inch wrench and loosen connector
I
(B).
Using 1-5/8 inch wrench to hold adapter (C), use 1-1/2 inch wrench and loosen connector (D).
Using hands, disconnect and remove tube (E) from powerplant.
Using 1-5/8 inch socket, remove adapters (A) and (C) and gaskets (F) and (G). Throw
gaskets away.
Using 1-5/8 inch wrench to hold adapter (H), use 1-1/2 inch wrench and loosen connector (J).
Using 1-5/8 inch wrench to hold adapter (K), use 1-1/2 inch wrench and loosen connector (L).
Using hands, disconnect and remove tube (M) from powerplant.
Using 1-5/8 inch socket, remove adapters (H) and (K) and gaskets (N) and (P). Throw
gaskets away.
Go on to sheet 3
6-186
Change 4