TM 9-2350-222-20-1-3
THERMOSTATIC TRANSMISSION OIL COOLER VALVE ASSEMBLY (RIGHT SIDE)
TEST AND REPLACEMENT (2D ENGINE) (Sheet 3 of 7)
REMOVAL:
Place rags (Item 65, Appendix D) under tube
1.
end fittings (A) and (B) on transmission.
NOTE
It may be necessary to hold
adapters (C) and (D) with 1-5/8
inch wrench while removing tube
end fittings (A) and (B).
2.
Using 1-1/2 inch wrench, remove tube end
fitting (A) from adapter (C).
3.
Place rags under tube end fittings (E) and (F)
at oil cooler.
NOTE
I t may be necessary to hold
adapters (G) and (H) with 1-5/8
i n c h wrench while removing
tube end fittings (E) and (F).
Using 1-1/2 inch wrench, remove outside
tube end fitting (E) from adapter (G).
Displace tube (J).
Using 1-5/8 inch wrench, remove adapter (G).
Using 1-1/2 inch wrench, remove tube end
fitting (F) from adapter (H).
Go on to Sheet 4
TA139536
6-169