ENGINE OIL COOLER REP ACEMENT (2D ENGINE (Sheet 3 of 6)
Using 1/2 inch socket with extension through
harness and into bracket, remove two screws
and washers (H).
Lower harness from coolers with bracket
Using 1/2 inch socket, remove four screws and
washers (J) holding oil cooler screen to cooler.
Remove oil cooler screen from cooler.
Support oil cooler to keep it from falling while doing step 13.
13. Using 3/4 inch wrench, remove four screws and washers (K) holding oil cooler frame.
14. Lift away oil cooler and mounting brackets,
Go on to Sheet 4