TM 9-2350-222-20-1-3
TRANSMISSION OIL COOLER SCREEN REPLACEMENT (Sheet 1 of 2)
TOOLS:
1/2 in. socket with 1/2 in. drive
6 in. extension with 1/2 in. drive
Ratchet with 1/2 in. drive
1/2 in. combination box and open end wrench
3/4 in. combination box and open end wrench
P R E L I M I N A R Y PROCEDURES:
Remove both air cleaner outlet hose assemblies (page 7-73)
NOTE
Left side shown, right side similar.
REMOVAL:
NOTE
If removing 2A engine screen, go to step 6.
1.
Using socket, extension, and ratchet through
harness and into bracket, remove two assembled
washer screws (A).
NOTE
You will have bracket (B) and tube (C) only
if your vehicle is equipped with a 2DA
engine.
2.
Using socket, extension, ratchet, and 1/2
inch wrench, remove screw (D) and locknut
(E) securing clamp (F) and tube (C) to bracket
(B).
3.
Using 3/4 inch wrench, remove bolt (G).
4.
Using socket, remove assembled washer screw
(H), screw (J), and washer (K) securing bracket
(B) and oil cooler screen (L).
Remove bracket (B) and oil cooler screen (L).
5.
6.
For 2A engine; using socket, remove four screws (J)
and four washers (K) securing oil cooler screen (L).
Remove oil cooler screen (L).
Go on to Sheet 2
TA249063
6-120
Change 2