CRANKCASE BREATHER TEE AND REAR TUBE REPLACEMENT (Sheet 3 of 6)
Using screwdriver, remove four clamps
(A) and two hoses (H) from breather tube
(B). Throw hoses away.
Perform steps 8 through 11 only if your
vehicle is equipped with a 2DA engine.
Using screwdriver, loosen two clamps (J).
Using one wrench to hold nut (K), use another
wrench and remove screw (L) securing clamp
(M) to bracket on left ejector tube (N).
Throw nut away.
Remove clamp (M) from engine breather
tube extension (P).
Remove engine breather tube extension
(P), hose (Q), and clamps (J). Throw hose
Go on to Sheet 4