MULTIPLE FLUID PRESSURE LINE CONNECTOR REPLACEMENT (Sheet 4 of 6)
Connect hose (D) to connector (A).
Using 1 inch wrench, tighten hose connector
(D). Make sure connector (A) is installed with
hose fittings pointed down.
Connect hoses (E) and (F) to connector (A).
Using 11/16 inch wrench, tighten connectors
(E) and (F).
Position hose (F) so that free end passes
through right engine shroud. Using fingers and
screwdriver, position grommet (G) over hose
and into shroud.
Go on to Sheet 5