TM 9-2350-222-20-1-3
TRANSMISSION MOUNTS (LEFT AND RIGHT) REPLACEMENT (Sheet 1 of 4)
PROCEDURE INDEX
PROCEDURE
PAGE
I
Removal
Cleaning and Inspection
Installation
TOOLS:
3-1/8 in, socket with 3/4 in. drive
T-slide handle with 3/4 in. drive
Diagonal cutting pliers
36 in. extension with 3/4 in. drive
Slip joint pliers
1-1 /2 in. open end wrench
1-1/2 in. socket with 3/4 in. drive
3/4 in. socket with 1/2 in. drive
1-5/16 in. open end wrench
Bench vise
Torque wrench with 3/4 in. drive (0-600 lb-ft) (0-813 Nm)
Bit screwdriver with 1/2 in. drive
Torque wrench with 1/2 in. drive (0-175 lb-ft) (0-237 Nm)
Ball peen hammer
SPECIAL TOOLS: Remover tool (Item 34, Chapter 3, Section 1)
SUPPLIES: Dry cleaning solvent (Item 54, Appendix D)
Goggles (Item 74, Appendix D)
Rubber gloves (Item 73, Appendix D)
Lockwire (Item 59, Appendix D)
Rags (Item 65, Appendix D)
Self-locking nut
Lockwasher
Lockwasher(3 required)
PERSONNEL: TWO
PRELIMINARY PROCEDURE:
NOTE
The procedure applies to both right and left transmission
mounts.
Go on to Sheet 2
6-9
Change 4