2A ENGINE AND 20 ENGINE POWERPLANT TESTS (GROUND HOP) (Sheet 12 of 15)
19. After adjusting servobands, repeat steps 15 thru 18, If slippage still exists, notify support
20. When tests are completed, shut down engine (TM 9-2350-222-10).
21. Using 3/4 inch wrench, back off hex head bolt to release brake.
22. Using 3/4 inch wrench, back off nut to release brake applicator tool from brake housing.
23. Remove brake applicator tool from brake housing.
24. Install right brake slave cylinder (page 13-67).
25. Install left brake slave cylinder (page 13-62).
Go on to Sheet 13