TM 9-2350-222-20-1-3
2A ENGINE AND 2D ENGINE POWERPLANT TESTS (GROUND HOP) (Sheet 8 of 15)
STALL TEST:
NOTE
Before performing stall test, check brake adjustment (page 13-2)
1.
Remove right brake slave cylinder (page 13-64).
2.
Remove left brake slave cylinder (page 13-60).
3.
Position brake applicator tool over rod sticking out of brake housing (where slave cylinder was).
4.
Engage catch on tool into notch in brake housing.
5.
Using 3/4 inch wrench, tighten nut to secure brake applicator tool to brake housing.
6.
Using 3/4 inch wrench, set brake by rotating hex head bolt until bottom of bolt is approximately
one inch from top of tube.
7.
Using torque wrench and 3/4 inch socket, tighten hex head bolt to 10-20 lb-ft (14-27 Nm).
Go on to Sheet 9
TA130285
Change 2 5-55