4-864 Change 3
At least 1/16 in. (1.6 mm) of thread on
track pin must extend through locknut.
Failure to comply may result in damage
to track pin and locknuts.
AO Tighten locknuts (1) and (7) to 120-160 lb-ft
Adjust track tension (TM 5-2350-262-10).
AL Loosen locknut (1) three turns. Drive track pin
(2) into track shoe (3) until washer (4) is flush
against track shoe (3).
AM Remove two track connecting fixtures form
AN Install washer (6) and locknut (7) on hull end
of track pin (2). Stop vehicle engine
(TM 5-2350-262-10), and relieve hydraulic
pressure (TM 5-2350-262-20-1).