3-22 Change 5
Lift and remove left and right floor plates (1) and (2).
Remove two self-locking screws (3) and left floor plate support (4) from rear of vehicle.
Reach through opening and clean debris from bilge pump inlet screen (5).
Start engine (p 2-37) and remove bilge pump lever to ON (p 2-2). Using hand, check for air flow
from pump outlet (6). If no air is expelled, or bilge pump does not operate,
notify unit maintenance.
Install left floor plate support (4) with two self-locking screws (3).
Although the Bilge Pump is considered Not Mission Essential and will no
longer be supported with spare and repair parts, this manual contains
operational procedures For Your Information Only. Notify Unit maintenance
if the bilge pump no longer operates.