TM 9-2350-222-20-1-4
REPLACEMENT OF HULL INTERMEDIATE LEAD ASSEMBLY (Sheet 2 of 4)
U s i n g slip joint pliers, unthread retaining
2.
nut (C) from shell (D). Slide retaining nut
(C) back along cable.
Slide sleeving (E) back along lead assembly (F)
3.
Slide bushing (G) back along cable.
4.
Remove pin (H) from position "C" of insert (J)
5.
pull lead assembly (F) back through bushing (G) and retaining nut (C).
6.
Using diagonal cutting pliers, cut tie downs securing lead assembly (F) to harness bundle
7.
end working back toward driver's compartment, pull lead assembly (F) from beneath
retaining straps.
At dust detector warning light box (K) in
8.
driver's compartment, disconnect lead
assembly connector (L) from short lead
(M) on dust detector warning light wiring
harness (N).
Remove hull intermediate lead assembly
9.
(F) from vehicle.
Go on to Sheet 3
TA250641
10-350.10
Change 3