TM 9-2350-222-20-1-4
HEADLIGHT ADJUSTMENT (Sheet 2 of 2)
9.
Turn on service drive headlights, low beam (TM
9-2350-222-10).
10.
Center of maximum light intensity should be
centered on line (D).
11.
If not, using 9/16 inch wrench, loosen three
screws (G) and adjust by tilting headlight (H) to
desired angle.
NOTE
Adjust
both
left
and
right
headlights in same manner.
12.
Using 9/16 inch wrench, tighten three screws
(G).
13.
Check to see if light intensity for left headlight
is centered on intersection of lines (D) and (E).
14.
If not, using 7/16 inch wrench, loosen three
screws (J) at base of headlight.
15.
Turn headlight (H) until in proper position.
16.
Using 7/16 inch wrench, tighten three screws
(J) when adjusted.
Repeat steps 13 through 16 for right headlight,
17.
using lines (D) and (F).
18.
Turn off lights (TM 9-2350-222-10),
End of Task
10-237